Inhalt - CrazyDrill Cool XL - the new deep hole drills from Mikron Tool

  • Oktober 26, 2010

CrazyDrill Cool XL - the new deep hole drills from Mikron Tool

October 26, 2010. Agno, Requirements on productivity increase and at the same time costs must be reduced. Not easy when deep holes are involved and a conventional deep hole drilling system shows acceptable results, but the drilling process is technically demanding and time and cost is substantial. Mikron Tool SA Agno presents a new small drill, within the well proven CrazyDrill product range.

CrazyDrill Cool XL is available with cutting lengths of 15 x d, 20 x d and 30 x d, starting from diameter 1 mm and 40 x d, starting from diameter 2 mm! For this new product the Swiss tool manufacturer has developed a new cutting geometry to meet the particularly challenging conditions of deep hole drilling perfectly. The result is a ingeniously designed drill, which produces short chips with all steel alloys. Working with hole depths of 40 x d this is a indispensable condition for a trouble free evacuation of the chips. The drill is designed to reach the full depth without pecking in one single stroke. Thus allowing highest speeds and feeds. With the aid of through tool internal cooling the cutting conditions at the tip are perfect and a good tool life is guaranteed.

A convincing feature, which justifies the use of the extra long CrazyDrill Cool is its performance. The following practical examples show the potential of the new CrazyDrill Cool:
1. Hole Ø 1.3 mm, depth 3.9 mm (30 x d), material 100Cr6 ball bearing steel. The hole is drilled in one single stroke with a cutting speed of vc of 60m/min (n =14700 rpm/min) and a feed of 0.06 mm/rpm (v1 = 881mm/min).
2. Hole Ø 4 mm, depth 160 mm (40 x d), material 14CrNi14. One single stroke with a cutting speed of 100 m/min (n = 8000 rpm/min) and a feed of 0.2 mm/rpm (v1 = 1600 mm/min).

We will be pleased to send you detailled informattion about CrazyDrill Cool XL.